14x14 Water to Air Heat Exchanger 1" Copper Ports With Install Kit

14x14 78,400 BTUs / 100 PSI For use in your hot air furnace plenum.

Other sizes available.

Please see charts in pics above

***Not recommended for air compressors***

 This listing includes the install kit.

Information about our heat exchangers

This heat exchanger is perfect for use in a 14"x15" plenum or larger. The copper ports measure 1" and are positioned on the 14" side (shown as the vertical side in the above picture). The fins cover an area of 14"x14", with a 1" frame on the opposite end to cover the copper elbows. This extends the length of the area inside your plenum by 1". The exchangers are all 3 1/2" thick and have a triple pass design with 12 fins per inch of aluminum fins. Tubing is made of 1/4" copper. Additionally, our exchangers come with a flat front face for easier installation and increased plenum strength. The outlets are also 1" copper and can be installed using sweat fittings or push fit type fittings, such as Sharkbite's. 

Installation brackets for installing water to air heat exchangers inside of furnace plenums. This easy to install kit takes all of the work out of installing a coil.  Great for the do it yourselfer or the seasoned installer.

This kit will work with most coils being sold on other sites that are 3.5" wide. Check before you buy, but that will cover over 90% of the ones being sold. Even most that are listed as 4"  are actually 3.5". These will work with every heat exchanger being sold elsewhere and our website store.

 We provide a limited lifetime warranty against manufacturer's defects.

 Dealer inquiries welcomed.

These heat exchangers are to be hooked up to a boiler or a chilled water source.

These heat exchangers can also be used as a stand alone heat source by simply attaching a fan or squirrel cage to one side of the unit. They can be installed in either the hot air side or the cold air return of a furnace. Please note that if installed in the cold air return you will need to install a 3 way zone valve in order for the fan to operate properly.

This heat exchanger is of a new style which does not require bending of your duct work. 

This new style heat exchanger can be easily installed by just slipping it into the plenum and attaching with self threading screws.  You will not need any special tools to install.  This unit is easier to install than others on the market because it attaches from the front instead of the side.

Water  to  Air heat exchangers, often called duct coils or furnace radiators, are used for installing into forced air furnace to provide heat from hot  water.  They are  usually installed into the cold air  side of the furance if that is the best option. They work in much the  same way as  the  central air conditioning unit.